In order to get the M40 to idle ok while the engine was cold I adjusted the mixture setting to run richer. Obviously this was providing enough fuel to stop the engine cutting out while the plenum was filling with as much air as the cylinders could gulp through the gap in the manifold gasket. It runs and drives ok in this setting, but idles quite high (about 1100rpm) and you can smell the stink of neat petrol out of the exhaust. Ok for short trips shunting the project car around but will need addressing to enjoy it before summer ends!
The real problem began when I had repaired the gasket, got the engine running smoothly and then tried to reset the AFM back to a stock, or near stock value. To begin with I had been putting marks and taking photos to recall where the settings were before I started messing, but you know how it is, once you get immersed into a several day long tweaking session (take that as you will!) the tendency is to get lost along the way.
I gave up trying in the end and decided the only way to dial this engine in and be sure I was not fighting with a dodgy AFM was to buy one that had not been messed with. This is in my interests anyway, as I got one from a car with far lower miles on it so the carbon-track is less worn and I know the air-temp sensor is OK too, which was a doubt with the original one.
No comments:
Post a Comment