F10/F11: DPF Replacement / Removal - EASY GUIDE!

If you are removing your DPF and re-mapping, or if your filter is clogged past the point of a re-gen, then you will need take it off. Getting the DPF / catalytic-converter off an F10 is easier than it looks and is totally doable at home without a set of workshop ramps. I managed with a jack / axle-stand and without removing the exhaust or any of the engine.

1. Safely raise the car.

2. Under the car, remove the centre under-tray that covers the exhaust joint to the DPF by undoing a series of 8mm screws.

3. Loosen the collar-bolt at the joint between the front section of the exhaust and the flexi coming from the DPF using a 14mm socket.

4. Slide the exhaust back about an inch until it pops out of the sleeve in the DPF. [It may help here to pop the exhaust out of the centre rubber-hanger to give more rearward movement.]

5. Under the bonnet, unplug the two O2-sensors and the Lambda sensor, then pull the hose off the metal-tube that runs to the pressure-sensor. Free up the wiring.

6. Remove the upward-facing O2-sensor using a 14mm open-ended wrench.

** Access to the bolts and sensors may be easier with the plastic air-inlet loosened and moved out of the way. **

7. Loosen the collar-bolt joining the front of the DPF to the back of the turbo using a 13mm socket on a long extension and move the collar forward away from the DPF.

8. Remove the upper nut and lower bolt holding the bracket to the rear of the DPF using a 13mm wrench.

9. Remove the two bolts holding the bracket to the back of the engine-block using an E10 double-hex socket, or an 8mm ring-spanner and fully remove the bracket.

10. The DPF will likely be solid in place, so the best bet is to wiggle it from underneath car until it breaks free and can be safely lowered down.

11. With the DPF free, getting it out of the engine-bay is still not a walk in the park. The lower O2 sensor and/or Lambda sensor may need to be removed to get the angle required to slide the body of the DPF down past the steering-knuckle and foil heat shield, which may need to pressed in towards the body a bit to give enough clearance. Eventually, the DPF can be manipulated down through the gap and drop down under the car, so watch out if you have it raised a fair bit off the ground.

12. Re-fitting is a reverse of the above steps. Note, all but the lower O2-sensor should be fitted after the DPF is secured in position. The easiest way to reposition the DPF is get someone to hold it from below high enough for you to get hold of it from inside the engine-bay and lift it up into position, rather than one person trying to reposition it from underneath.