Changed the injector seals last Sunday and gave the ports another good clean. The mist has stopped, but it still did not want to fire. There is fuel to the injectors and the timing is spot on, so this could only mean 2 things - something electronic isn't working properly, or the entire DDE module has fallen out of sync with the engine...
I don't even want to know what the latter option entails, so carried on swapping sensors on the new engine for those that worked on my old one. I found the crank-sensor was completely covered in dirty oil, in fact the whole slot was filled with it. Engine sensors are funny things and I can see how the oil could stop it from seeing the notch on the flywheel, but it doesn't explain why the engine would not turn over well using a can of Easy-Start. Either way, with the crank-sensor from my original lump in place it fired up straight away! Result.
[Video is with EGR-pipe disconnected and no air-filter / muffler fitted.]
- PAS-pump sounds like it's dying - extreme whine / groan when the wheel is turned - and is now the only thing keeping her off the road. Will try bleeding tomorrow and maybe fresh fluid, but failing that the pump could have packed in or, worse, I've damaged some of the piping / rack while lifting the engine in.
- Rear rubber exhaust-hanger missing. TIS says to remove the screws holding the hanger-bracket, not remove the rubber. I cut mine off to hastily get the exhaust down and will have to buy and annoyingly fit a new one.
- Front exhaust vibration-damper simply will not fit. When fitted to the exhaust, the eyelets on the two connecting-rods are way off the studs on the gearbox-bracket. The left-right rod is only about 5mm out, but the front-rear rod is miles off. I will have to remove the rear and centre brackets and try to relocate the exhaust a bit.
Other than that, no iDrive messages, no engine-management light, no 'Increased Emissions', no leaks, no mist and no funny noises. The gearbox and clutch are working fine and the car is desperate to be driven. Curse that power-steering fault!
No comments:
Post a Comment