Sat 6.7.15:
6 months tax.
2 new front tyres.
4 new brake discs.
New master-cyl. / servo.
Fuel tank repair.
Replacement front bumper.
- Re-bled brakes.
- Wynn's Engine Stop-Leak and half a litre oil.
- Rad-hose repair-tape kit, cable-tie out of way, 1 litre water/coolant.
- Cleaned wiring-connectors to cam-sensors.
- Cleared all oil residue from exhaust-manifold.
Quick run of engine with NO MAF connected gives improved idle-speed of 900rpm. After revving, it drops below 900 for a moment, then returns to 900.
Brakes are bled and still very stiff. No servo assistance is present, but the servo and m/c are known to be working. Could the problem be the vacuum pump? Could this be causing the oil leak?
If not, then it feels a little too low for the rocker-cover and will most likely be coming from the rear main-seal, which is a gearbox off job, so lets hope its just draining from one of the rear rocker-cover plugs and running down the head.
Tues 15.7.14:
Replace vacuum-pump.
Replace both camshaft-sensors.
Replace MAF sensor.
Remove inlet-manifold to check CCV and crank-sensor.
Clean oil and recondition inlet-manifold.
No comments:
Post a Comment