E60: Replacing headlight-washer caps / hinges!

Despite how it looks, you can't replace them with the bumper on. This is best done while the whole front bumper is off the car, but thesis the quick and dirty method, of course.

1. Lift each cap out of the bumper on the hinge and remove them by depressing the clips at the back and sliding the lugs out of the hinge.

2. Remove the screw holding each corner of the bumper to the wing using a 10mm wrench.

3. Pop the corner out of the wing and bend it out enough to reach behind the headlight-washer cap.

4. Remove the hinge / lever by bending one side out and unhooking it from the outer lugs, the other side should then come away easily.

5. Remove the spring by squeezing the coils towards each other and unhooking them from the inner lugs.

6. Fit the new spring as a reverse of removal.

7. Lift the spring up forwards and fit the new hinge / lever as a reverse of removal, then release the spring ensuring it is tight against the flat-bar on the hinge.

8. Refit each corner of the bumper.

9. Lift the hinges / levers out of the bumper and fit the caps.