Pages / Stickies

Friday, 11 October 2013

E21 316: Update + MOT Pass

After my disastrous few weeks I managed to get hold of a Bilstein strut-insert and get it onto the car along with the longer springs, meaning it was finally back on the road and in an state worthy of the MOT test. I cautiously rolled down to the test-station on Saturday and am glad to say the E21 passed with flying colours!

Bilstein damper is strong, but will be a pain with the short springs.
This was a relief considering the slightly dodgy seat-frames I made bolted through the floor-pan, which stuck out like a sore thumb when it was up on the ramps, along with the scuff marks where I've grounded the underside, but with the car at a more standard height off the ground this didn't see to bother them and there was no problem with the chassis at all.

Oddly, the guy told me that the split-pins were missing from the castle-nuts on my steering track-rod ends and this would actually be a fail under normal circumstances, but they could see I'd been working on it and decided to give me the benefit of the doubt. This was true, I'd had them off swapping the springs and hadn't bothered to replace the split-pins as they would be coming straight off again to put the short springs back. That was decent of them to let it go, as it would have been beyond frustrating to lose another week to something so trivial and shows just what a pain the UK MOT test is.

Folded up and with a 1/4 inch thick layer of
pallet-wrap to send as a parcel.
Spending on the E21 has been a bit out of control since buying the E30 seats and it is still in desperate need of the wheel-arches finishing off. By this point, I'm past what I can recoup if I sell the car. I'm still using my E39 as my daily, the E21 has had no use for nearly a month with no MOT and finally, due to a planned move, it's looking like I will have to let her go anyway, unless I can find somewhere cheap enough to store it. I had hoped to have the arches skimmed off and painted by the guy who did the respray, but money is tight so I will be buying a rattle-can and doing the best I can with them.

Thankfully, I've managed to generate a bit of extra cash to pay for the strut-debacle [this post], by selling some bits on eBay, like a battered old set of alloys, an E36 nose-cone and other bits I had lying around, as well as the original beige passenger seat from the E21 - I think I have enough seats for the car now. I hope the seat arrives to the buyer OK, as I had to practically shrink-wrap it to be able to send it Parcelforce [£27], pictured, as the original method of courier was just over £60!

My spare set of E21 ash-trays is not selling on the other hand and is still on the site here - http://www.ebay.co.uk/itm/181235987123.